Dynalite DMC810GL User Manual download pdf (Page 13)

An introduction to the Philips Dynalite control system 13

Low-level integration

DyNet RS485

3 Twisted Pair

& Overall Screen

DyNet Network Spur

DyNet Network Trunk

DyNet Network Spur

DTK622

PC Node

1 Phase 1A

DyNet Network Spur

Relay Controller

DDRC810DT DDBC1200

1 Phase 1A

Ballast Controller

Input

Interface

Dry Contact

Digital Outputs

1-10VDC

Analogue Outputs

Digital / Analogue

Inputs

DDMIDC8

4 x 10A Leading Edge Dimmer

1 Phase 40A

CH 1

CH 2

CH 3

CH 4

2 Core + Earth

Load (Outputs)

DLE410

DLP9100

10 Button

‘Configurable’ Panel

DTC602

Timeclock

Network Bridge

DNG485

1 Phase 1A

The input interface works much in the same way as a user

control panel, except that the ‘virtual button press’ is initiated

by a relay closure from the security system or any control

system with a relay output, such as an alarm system. This, in

a simple example, would send a message across the network

such as ‘Area 2 go to Preset 1 over 5 seconds’. Again, all of the

load controllers in the system would listen to the message and

respond as previously described. Analogue inputs can also be

programmedinasimilarwaytodirectlyrampspecicchannels

or areas up and down, or to send out a preset message at a

predetermined input level.

Philips Dynalite relay and ballast controllers are used to

provide dry contact digital and 1-10V analogue outputs,

which can be programmed to represent the state or level of

a channel or area. Much as the Philips Dynalite system can

receive inputs from other systems, the outputs can be used to

provide status or command information to another system.

Figure 08 > Wiring connection for low-level 3rd party integration to the DyNet system

Another common method of control is to enable interoperability

with other systems, such as security and access control. Where

there are a limited number of functions controlled by either

system, the most convenient method is often by way of a low-level

interface through dry contact digital or 1-10V inputs and outputs,

as shown below;

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Dynalite DMC810GL User Manual Page 13

Comments to this Manuals